Handmade D2 Steel Tanto Combat Sword Knife

Where Knife Ends and Sword Begins

At 24 inches overall with an 18 inch blade, this handcrafted tanto sits at the boundary between long knife and short sword and it is more capable than either label suggests. Built from premium D2 tool steel with a stacked leather washer handle and steel crossguard, this is a piece that commands attention in any collection and delivers genuine performance in the field.

The Blade — Tanto Combat Style
The tanto blade profile is rooted in Japanese sword-making tradition — a thick, angular tip geometry that prioritises strength and penetration above all else. Where conventional hunting blade tips taper to a fine point that can snap under lateral stress, the tanto tip is reinforced by a secondary bevel that distributes force across a wider area.

At 18 inches this blade delivers:

• Formidable reach and cutting power across the full blade length
• An angular reinforced tip built to withstand hard piercing without failure
• A clean satin finish that balances visual appeal with practical field performance
• Single edge ground for maximum slicing capability with full control

This is not a knife that whispers. It is a blade that makes a statement.

The Steel — D2 Tool Steel
Few steels earn the loyalty of serious blade makers the way D2 does. With approximately 1.5% carbon and 11–13% chromium content, D2 occupies a unique position — tougher than conventional stainless, sharper-holding than most carbon steels, and capable of enduring conditions that would destroy lesser materials.

Hardened to 58–62 HRC on the Rockwell scale, this blade delivers:

• Long-lasting sharpness that holds through demanding cutting tasks
• Abrasion resistance that keeps the edge intact through heavy outdoor work
• Adequate flexibility to handle impact without chipping or cracking
• Semi-stainless properties that resist corrosion better than standard carbon steel

Care tip: A light wipe of blade oil after use keeps D2 performing at its best for decades.

Full Tang — One Piece from Tip to Pommel
The D2 steel on this knife runs 24 inches from blade tip through crossguard, through every leather washer, to the steel pommel cap. A single, unbroken piece of steel. At this length and weight, anything less than full tang would be a structural liability. This is built the way long blades have always been built as one.

The Handle — Striped Rosewood with Silver Bolster
The handle on this knife is crafted from striped rosewood, a naturally occurring grain pattern in rosewood where dark and light tones alternate in flowing parallel lines along the wood. The result is a handle with extraordinary visual depth and warmth that contrasts beautifully against the satin steel blade.

Rosewood is one of the most durable natural handle materials available. Naturally dense and oily, it resists moisture absorption, temperature changes, and hard use without cracking or warping. The striped grain makes every handle subtly unique, no two pieces of striped rosewood look exactly alike.

The silver steel bolster provides a clean, strong transition from blade to handle,
protecting the wood at its most stress-prone point while adding a refined, classic appearance that elevates the overall look of the knife.